Mathgal60
I am having a hard time printing within the circles.  Should the plastic go into the printer first or the icing end?  Should I be using the bottom feeder tray or the top?  I've wasted two sheets so far!  Help!
Quote 0 0
Trout Man
Use rear tray to print on pre-cut sheets. Make sure side sheet guides keep sheet straight. Only feed one sheet at the time.
Feed always plastic lip first, make sure you are using correct template in our Print a Cake software or corresponding template in OL program.
Quote 0 0
Mathgal60
Thank you so much for the response and directions.  I'll try it!
Quote 0 0
Mathgal60
It didn't work.  Is there a setting I need to change?
Quote 0 0
Mathgal60
I'm pretty frustrated.  I've tried pre-cut circles of all sizes, and none of them print properly.  I will not buy these again. I've wasted way too much money!!
Quote 0 0